P 8/10
Repair
[3] -6. Replacing the Electrical Parts in Handle Section
Remove Handle cover by unscrewing four 4x18 Tapping screws on Motor housing section. (Fig. 28)
Electrical parts in Handle section can now be replaced.
Fig. 28
Handle cover
Tapping screw 4x18 (4 pcs)
Motor housing section
[4] ADJUSTMENT
Note: Be sure to unplug the tool before making the following adjustments.
[4] -1. Squaring Adjustment of Saw Blade
The angle of Saw blade to Base plate is adjusted to 90 degrees in factory. But if out of adjustment, apply a triangular rule or 1R208 to Saw blade and Base plate, then turn Hex socket set screw M5x8 with Hex wrench 2.5 until Saw blade is square to Base plate. (Fig. 29)
Fig. 29
triangular rule (or 1R208) |
Base plate |
Hex wrench 2.5 |
Hex socket set screw M5x8 |
[4] -2. Adjustment of Two Lever 56's
Each of the two Lever 56's (the one used for bevel angle adjustment and the one used for cut depth setting)
must be fixed in place so that it can be locked at an angle of between 0 and 30 degrees as illustrated in Figs. 30, 31.
Fig. 30
Lever 56
(the one used for
bevel angle adjustment)
30 degrees
Base plate
Fig. 31
Lever 56 |
(the one used for |
cut depth setting) |
30 degrees |
Base plate |
