14.REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on.
15.AVOID UNINTENTIONAL STARTING. Don’t carry tool with finger on switch. Be sure switch is OFF when plugging in.
16.EXTENSION CORDS. Make sure your extension cord is in good condition. When using an extension cord, be sure t o use one heavy enough t o carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Table 1 shows the correct size t o use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord.
TABLE 1 MINIMUM GAGE FOR CORD SETS
|
| I |
| Total Length of Cord in Feet | I 101 - 150 | |
|
| I | 0 - 25 | I 26 - 50 | I 51 - 100 | |
Ampere Rating |
|
|
|
| ||
More |
| Not More |
|
| A W G |
|
Than |
| Than |
|
|
|
|
0 | - | 6 | 18 |
|
|
|
6 | - | 10 | 18 | 16 | 14 | 12 |
10 | - | 12 | 16 | |||
12 | - | 16 | 14 | 12 |
|
|
17. OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only extension cords intended for use outdoors and so marked.
18.STAY ALERT. Watch what you are doing, use common sense. Don’t operate tool when you are tired.
19. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged should be carefully’checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized serv- ice center unless otherwise indicated elsewhere in this instruction manual. Have defective switches replaced by authorized service center. Don’t use tool if switch does not turn it on and off.
20.GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded surfaces. For example; pipes, radiators, ranges, refrigerator enclosures.
21 . REPLACEMENT PARTS. When servicing, use only identical replacement parts.
22. POLARIZED PLUGS. To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. Ifit still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
3
