Installing or removing the bit
CAUTION :
Always be sure that the tool is switched off the bit.
Use only the driver bit or socket bit shown a t right. Do not use any other driver bit or socket bit.
To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. Then re- lease the sleeve to secure the bit.
and unplugged before installing or removing
a6
9 m m (3/8“)
I Bit ISleeve
To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly.
NOTE :
If the bit is not inserted deep enough into the sleeve, the sleeve will not return to i t s original position and the bit will not be secured. In this case, try
Switch action
To start the tool, simply pull the trigger. Tool speed is increased by increasing pressure on the trigger. Release the trigger to stop.
CAUTION:
Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released.
Reversing switch action
This tool has a reversing switch to change the direction of rotation. Move the revers- ing switch to the 0 position for clock- wise rotation or the 0 position for counterclockwise rotation.
c
__Clockwise
Counterclockwise rotation
Reversing switch
5
