Switch action
o s e t the reversing switch lever just in front of the trigger switch to Forward (FWD) or Reverse (REV). Then pull the trigger to turn the tool ON and release it to turn it OFF. To change the direction of bit rotation, release the trigger, let the tool come to a complete stop, and then slide the switch lever to the opposite side. The trigger switch does not work if the switch lever is in the neutral position.
CAUTl ONS:
0 Before inserting the battery cartridge into the tool, always check to see that the trigger switch actuates properly and returns to the "OFF" position when released.
0 When not operating the tool, keep the lever switch in the neutral position.
0 Before operation, always check to be sure that the switch lever is set for the desired direction of rotation.
0 Pulling the trigger hard when the lever switch i s set to neutral can cause a switch break- age.
Holding tool
.When pushing down on the front of the tool, be careful not to touch the drill chuck or bit with your fingers or the palm of your hand.
Drilling in metal
.Punch a small hole in the metal to pre- vent the bit from skitterring when start- ing to drill a hole.
8
