Shindaiwa 80775 manual Troubleshooting Guide, No No No No, Enciende No Motor El, Guía, English

Models: 80775

1 16
Download 16 pages 45.36 Kb
Page 12
Image 12
Troubleshooting Guide

ENGLISH

Troubleshooting Guide

ENGINE DOES NOT START

What To Check

 

Possible Cause

 

Remedy

 

 

 

 

 

 

Does the engine crank?

NO

Faulty recoil starter.

 

Consult with an authorized servicing dealer.

 

 

 

Fluid in the crankcase.

 

 

 

 

 

 

 

YES

 

 

Internal damage.

 

Tighten and re-test.

 

 

 

 

 

Loose spark plug.

 

 

 

 

 

Good compression?

NO

 

Excess wear on cylinder,

 

Consult with an authorized servicing dealer.

 

 

 

 

 

 

 

piston, rings.

 

 

 

 

 

 

 

 

YES

12

Does the tank contain fresh fuel of the proper grade?

YES

Is fuel visible and moving in the return line when priming?

YES

Is there spark at the spark plug wire terminal?

YES

Check the spark plug.

NO

NO

NO

Fuel incorrect, stale, or contaminated; mixture incorrect.

Check for clogged fuel filter and/or vent.

The ignition switch is in “O” (OFF) position.

Shorted ignition ground. Faulty ignition unit.

If the plug is wet, excess fuel may be in the cylinder.

The plug is fouled

or improperly gapped.

The plug is damaged internally or of the wrong size.

Refill with fresh, clean unleaded gasoline with a pump octane of 87 or higher mixed with a 2-cycle air cooled mixing oil that meets or exceeds ISO-L-EGD and/or JASO FC classified oils at 50:1 gasoline/oil ratio.

Clean as required; restart.

Move switch to “I” (ON) position and re-start.

Consult with an authorized servicing dealer.

Crank the engine with the plug removed, reinstall the spark plug, and re-start.

Clean and re-gap the spark plug to 0.024 inch (0.6 mm). Re-start.

Replace the spark plug with a Champion CJ8Y or equivalent spark plug of the correct heat range. Adjust the spark plug electrode gap to 0.024-inch (0.6 mm).

.motor el encender Vuelva .CJ8Y .bujía la Cambie

.motor el encender a Vuelva .mm) 6.(0 .024pulg.0 a bujía la calibre y Limpie

.motor el encender a vuelva y bujía la poner a Vuelva .puesta bujía la sin motor el girar Haga

.Shindiawa distribuidor su con Consulte .motor el encender a vuelva y encendido (I) de posición la al Mueva

.motor el encender a Vuelva

.motor el encender a Vuelva

.defectuosa está bujía La

.húmedos o carbón de llenos estar pueden electrodos Los

.cilindro el en combustible de exceso hay húmeda, esta bujía la Si

.defectiva Bobina .defectiva tierra a Conexión .apagado (O) posición la en interruptor El

.necesario sea como Limpie/cambie .filtro el y alimentación de manguera las Revise

).50:1 proporción oil; mixing cycle-2 class FC JASO or EGD-L-ISO One Premium (Shindaiwa aceite con mezclada gasolina con Llene

NO

NO

NO

NO

.buj’a la Revise SI

bujia? la en Chispa buena ÀTiene

SI

manguera? la por circular y fluir combustible ve ÀSe

SI

limpio? y adecuado combustible tanque el ÀTiene

12

.Shindaiwa distribuidor su con Consulte

 

.anillos los

 

 

 

SI

 

 

 

 

 

 

 

 

o pistón cilindro, en excesivo Desgastes

 

 

 

 

 

 

 

n?—compresi ÀBuena

 

.motor el encender a vuelva y Apriéte

 

.floja Bujía

 

 

 

NO

Diagnóstico

 

 

.internas Averías

 

 

SI

 

 

 

 

 

 

 

 

 

 

 

.Shindaiwa dirtribuidor su con Consulte

 

.cárter el en Fluido

 

 

 

gira? motor ÀEl

 

 

 

 

 

.defectuoso Arrancador

 

NO

 

Guía

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Recomendación

 

Causa Posible

 

 

Revisar Que

 

 

 

 

 

 

 

 

 

 

Enciende No Motor El

 

Page 12
Image 12
Shindaiwa 80775 manual Troubleshooting Guide, No No No No, Enciende No Motor El, Guía, English