5.OPERATING PROCEDURES
1.STARTING THE ENGINE
ations as outlined on page 5.
(a)Open the fuel cock.
(b)Pull choke knob to close (choke cold start) position.
(c)Make sure that the “Auto Idle” switch is in the “OFF” position.
(d)Pull the starter handle slowly until re- sistance is felt. This is the ”Compression” point. Return the handle to its original
position and then pull swiftly.
If the engine fails to start after several attempts, repeat above procedures with choke knob returned to ”OPEN” posi- tion.
Do not fully pull out the rope.
After starting, allow the starter handle to return to its original position while still holding the handle.
(e)After the engine started, return the choke knob gradually to “OPEN” position.
(f)Warm up the engine without a load for a few minutes.
-9 -
