Makita G351O R, G571O R, G5711R, G341O R, G3511R manual WAlTAGE INFORMATION, 60HZ, 60Hz

Models: G3511R G341O R G351O R G5711R G571O R

1 44
Download 44 pages 51.83 Kb
Page 27
Image 27
6. WAlTAGE INFORMATION

6. WAlTAGE INFORMATION

Some appliances need a "surge" of energy when starting. This means that the

amount of electrical power needed to start the appliance may exceed the amount needed to maintain its use. See the chart on page 15 for appliances you may use with this generator.

Electrical appliances and tools normally come with a label indicating voltage, cycles/Hz, amperage (amps) and electrical power needed to run the appliance or tool. Check with your nearest dealer or service center with questions regarding power surge of certain appliances or power tools.

Electrical loads such as incandescent lamps and hot plates require the same wattage to start as is needed to maintain use.

Loads such as fluorescent and mercury lamps require 1.2 to 2 times the indicated wattage during start-up.

Electrical motors require a large starting current. Power requirements depend on the type of motor and its use. Once enough "surge" is attained to start the motor, the appliance will require only 50% to 30% of the wattage to continue running.

Most electrical tools require 1.2 to 3 times their wattage for running under load during use. For example, a 5,000 watt generator can power a 1800 to 4000 watt electrical tool.

Loads such as submersible pumps and air compressors require a very large force to start. They need 3 to 5 times the normal running wattage in order to start. For example, a 5,000 watt generator would only be able to drive a 1,000 to 1,700 watt pump.

NOTE :

The following wattage chart is general guide only. Refer to your specific appliance for correct wattagle.

To determine the total wattage required to run a particular electrical appliance or

tool, mutiply the voltage figure of the appliance/tool by the amperage (amps) figure of same. The voltage and amperage (amps) information can be found on a name plate which is normally attached to electrical appliances and tools.

 

 

Applicable Wattage (W)

 

 

Applications

G2410R

 

G3510R

 

G5710R

 

 

G3511R

 

G5711R

 

 

 

 

 

 

 

60HZ

 

60HZ

 

60Hz

 

Incandescent lamp, heater

2,000

 

3,000

 

4.800

 

IFluorescent lamp, mercury lamp I

1,200

I

1,800

I

2,900

I

Electric tool

1,200

 

1,800

 

2,900

 

Pump, compressor

500

 

700

 

1,100

 

Page 27
Image 27
Makita G351O R, G571O R, G5711R, G341O R, G3511R manual WAlTAGE INFORMATION, 60HZ, 60Hz