P 10/ 14
Repair
[3]DISASSEMBLY/ASSEMBLY
[3]-4. Switch Lever
DISASSEMBLING
(1)Remove Rear cover from Motor housing by removing 4x18 Tapping screw. (Fig. 2)
(2)Disassemble Switch lever and Switch knob from the machine as drawn in Fig. 11.
Fig. 11
1.While locking Switch knob with 1R281, strongly push Switch lever in a direction designated with black arrow.
2.Switch lever is disconnected from the locking claw of Switch knob. Then, remove Switch knob.
3.Bending Switch lever, pull out Switch lever from Motor housing.
1R281 | Switch knob |
|
Switch lever |
Switch lever 
ASSEMBLING
(1)Insert Switch lever into Motor housing. And push it until the loop portion comes into sight through Switch knob assembling hole on Motor housing. Refer to the right and center illustration in Fig. 11.
(2)Assemble Switch knob to Switch lever as drawn in Fig. 12.
Fig. 12
1.Make sure that Compression spring 4 is assembled to Switch lever in advance.
Switch lever
Compression spring 4
2.Fitting Switch knob to the loop portion of Switch lever and the claw portion of Switch plate, hold Switch knob. And then, release Switch lever. (The hook of Switch knob interlocks with the hole of Switch lever when Switch lever is pushed back to OFF position by Compression spring 4.)
Switch plate
Switch knob 
Switch lever
