Makita GA4541C, GA5043C, GA4043C, GA4543C, GA4041C, GA5041C dimensions Three Bond Loctite

P 9/ 14

Repair

[3] DISASSEMBLY/ASSEMBLY

[3] -3. Spiral bevel gear [large one], Ball bearings 696ZZ/ 6201DDW (cont.)

DISASSEMBLING

(3)Disassemble Ball bearing 6201DDW from Bearing box as drawn in Fig. 9.

Fig. 9

1.Clamp Bearing box with Vise. Then, while fitting the claw of 1R340 to the notch of Bearing retainer 20-33, turn 1R340 clockwise to remove the retainer.

Bearing retainer 20-33

	Bearing
1R340	retainer 20-33

Felt ring 17

2. Take out Felt ring 17 and Flat washer 21		3. Remove Ball bearing 6201DDW with Arbor press.
from Lead flange side of Bearing box.		Arbor press
Felt ring 17
Flat washer 21	Ball bearing
	6201DDW
		Ball bearing
		6201DDW

ASSEMBLING

Assemble by reversing the disassembly procedure. (Refer to Figs. 9, 8 and 7)

Note: • Do not re-use the removed Joint sleeve. New Joint sleeve has to be mounted. (Refer to the bottom center illustration in Fig. 7)

•Apply the following thread locker to the thread of M4x16 Hex socket head bolts if the unscrewed bolts are used.

*Three Bond 1342

*Loctite 242

(Refer to the upper left illustration in Fig. 7)

•Coupling, large Spiral bevel gear, Ball bearing 6903ZZ have to be assembled tightly that there is any gaps among them. See the left illustration in Fig. 10.

Fig. 10

Incomplete assembling causes gaps.