P 15/17
Wiring diagram
[2] Wiring in Handle Base and Handle
Low Voltage Areas where Radio Interference Suppression Is Required
Fig. D-4B
Put the slack portion of | Handle base, | Fix Grounding wire (clear) |
Grounding wire in this space. | viewed from Controller side | with this Lead wire holder. |
Grounding wire (clear) |
| Terminal of Grounding wire |
Fix Grounding wire (clear) |
| Lead wires covered with |
with this Lead wire holder. |
| |
| Polyolefin tube (black) | |
|
| |
Controller |
| red |
|
| |
Route all of the Controller's |
| white |
|
| |
Lead wires and grounding |
|
|
wire (clear) through this slit. |
| Pass these Lead wires from Controller |
|
| |
Fix the following Lead wires of |
| and Connector housing A through |
Controller with this Lead wire holder: |
| the hole illustrated to right in Fig. |
*Grounding wire (clear) |
|
|
*Lead wires (black, red) to Connector |
|
|
housing A | Connector housing A | |
| ||
Controller
The Lead wires to Connector
housing A must be tight between
Controller and Lead wire holder.
Fig. D-5B
Fix all of the Lead wires to Switch with this Lead wire holder of Switch holder complete.
Handle, viewed from Handle cover side
Switch holder
Switch
Route all of the Lead wires to Switch through between the boss and the rib.
Pass the following Lead wires through this hole:
*Noise suppressor's Lead wires (black)
*Controller’s Lead wires covered with Polyolefin tube (black)
*Lead wire (red) from Connector housing A
*Controller's Lead wire (white)
Put the slack portion of
Lead wires in this space.
Pass Controller’s Lead wires covered with Polyolefin tube (black) between Switch and Switch holder's wall.
rib |
| |
boss | Handle Base, | |
viewed from Handle side | ||
|
Pass Grounding wire (clear) through the hole illustrated to right in Fig.
Grounding wire (clear) |
Noise suppressor |
