1. Connector
1
014036
1
014041
1. Hammer grease
Remove the connector by pulling it.
1. Change lever
3 2. Screw
3. Crank cap cover
1
2
014038
Loosen the screws and remove the change lever. Remove the crank cap cover.
Wipe out the old grease inside and replace with fresh grease:
For model HR4003C, HR4013C: 30g (1oz)
For model HR5202C, HR5212C: 60g (2oz)
Use only Makita genuine hammer grease (optional accessory). Filling with more than the specified amount of grease can cause faulty hammering action or tool failure. Fill only with the specified amount of grease.
Reinstall all removed parts.
1. Connector
1 |
014039 |
Remove the control plate.
1. Control plate
1
014042
Attach the connector and reinstall the handle.
NOTE:
Note that the different lengths of screws are used.
NOTICE
• | Do not tighten the crank cap excessively. It is |
2
1
1
1
1.Screws
2.Crank cap
made of resin and is subject to breakage. |
• Be careful not to damage the connector or lead |
wires especially when wiping out the old grease or |
installing the handle.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
014092
Loosen the six screws and remove the crank cap. Rest the tool on the table with the bit end pointing upwards. This will allow the old grease to collect inside the crank housing.
10
