ASSEMBLY
CAUTION:
•Always be sure that the tool is switched off and unplugged before carrying out any work on the tool.
Side handle
003139 |
CAUTION:
•Use the side handle only when chipping, scaling or demolishing. Do not use it when drilling in concrete, masonry, etc. The tool cannot be held properly with this side handle when drilling.
The side grip swings around to either side, allowing easy handling of the tool in any position. Loosen the side grip by turning it counterclockwise, swing it to the desired position and then tighten it by turning clockwise.
Bit grease (optional accessory)
Coat the bit shank head beforehand with a small amount of bit grease (about 0.5
Installing or removing the bit
1. Bit shank
2. Bit grease
1 2
003150
Clean the bit shank and apply bit grease before installing the bit.
1. Bit
1
2
014034
1.Side handle
2.Clamp nut
2. Release cover 1 
2
014878
The side handle can be swung 360° on the vertical and secured at any desired position. It also secures at eight different positions back and forth on the horizontal. Just loosen the clamp nut to swing the side handle to a desired position. Then tighten the clamp nut securely.
Side grip
Insert the bit into the tool. Turn the bit and push it in until it engages.
If the bit cannot be pushed in, remove the bit. Pull the release cover down a couple of times. Then insert the bit again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely held in place by trying to pull it out.
CAUTION:
• | Always use the side grip to ensure operating |
| safety when drilling in concrete, masonry, etc. |
| 1. Side grip |
1
2
014879
1.Bit
2.Release cover
1 |
014027 |
To remove the bit, pull the release cover down all the way and pull the bit out.
7
