ADDITIONAL SAFETY RULES
1. Always wear safety goggles or safety glasses with side shield, and a full face shield when needed.
2.Do not point the ejection port at anyone in the vicinity (especially his face). Keep hands and feet away from the ejection port area.
3.Always remove the battery cartridge before loading the staples, adjustment, inspection, maintenance or after operation is over.
4.Make sure no one is nearby before operation. Never attempt to drive staples from both the inside and outside of wall at the same time. Staples may rip through and/or fly off, presenting a grave danger.
5.Watch your footing and maintain your balance with the tool. Make sure there is no one below when working in high locations.
6.Check walls, ceilings, floors, roofing and the like carefully to avoid possible electrical shock, gas leakage, explosions, etc. caused by stapling into live wires, conduits or gas pipes.
7.Use only staples specified in this manual. The use of any other staples may cause malfunction of the tool.
8.Do not tamper with the tool or attempt to use it for other than driving staples.
9.Do not operate the tool without staples. It shortens the service life of the tool.
IO.Stop driving operations immediately if you notice something wrong or out of the ordinary with the tool.
11.Never staple into any materials which may allow the staple to puncture and fly through as a projectile.
12.Never actuate the trigger switch and safety lever at the same time until you are preparedto staple workpieces. Allow the workpiece to depress the safety lever. Never defeat its purpose by securing the safety lever back or by depressing it by hand.
13.Never tamper with the safety lever. Check the safety lever frequently for proper operations.
SAVE THESE INSTRUCTIONS.
6
,
