Installing or removing battery cartridge
Always switch off the tool before insertion or removal of the battery cartridge.
.To remove the battery cartridge, pull out [ the set plate on the tool and grasp both sides of the cartridge while withdrawing it from the tool.
*To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Snap the set plate back into place. Be sure t o close the set plate fully before using the tool.
Battery cartridge
Set plate
v
0 Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being inserted correctly.
CAUTION :
If you pull out the set plate carelessly when extra staples and stored in the storage space in the tool, the extra staples can fall out and present a danger to anyone or anything below. Always hold the tool with the set plate facing up to prevent the extra staples from falling out when you pull out the set plate.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge so that Charging light
the plus and minus terminals on the bat-
tery cartridge are on the same sides as their Start button- respective markings on the fast charger.
Insert the cartridge fully into the port so that it rests on the charger port floor.
Press the start button (red). The charging light will come on and charging will begin. I f the charging light does not come on, press the reset button (yellow) first, then
the start button (red). If the charging light goes out within 10 seconds even after pressing the reset button and start button a couple of times, the battery cartridge is dead. (CAU- TION: Wait for more than 5 seconds after the charging light goes out to press the reset button again.) Replace it with a new one. When the charging light goes out after about one hour, you may remove the fully charged battery cartridge.
After charging, unplug the charger from the power source.
7
