Manhattan Computer Products 179133 Regulatory Statements, Important Pre-InstallationNotes, C-Tick

Regulatory Statements

FCC

This equipment has been tested and found to comply with FCC rules Part 15, Subpart B § 15.109/15.107 Class B. Operation is subject to the following two conditions:

•This device may not cause harmful interference; and

•This device must accept any interference received, including interference that may cause undesired operation.

CE

This equipment is in compliance with the requirements of the following regulations: EN 55022 Class B (2006); EN 55024 (1998+A1:2001+ A2:2003); IEC/EN 61000-3-2 (2006); IEC/EN 61000-3-3 (1995+A1 :2001+A2 :2005); (IEC/EN 61000-4-2 (1995+A1 :1998+A2 :2001)/-3 (2006)/-4(2004)/-5(2006)/-6 (1996+A1 :2001)/-11 (2004)

C-Tick

This equipment is in compliance with the requirements of the following regulations: eNE 55022 (2006); AS/NZ�S CISPR22 ��© IEeC: 2005.

VCCI

This equipment is in compliance with the requirements of the following regulation: CISPR22 ©� IEC: 2005.

Important Pre-Installation Notes

•Unplug any USB 2.0 VGA adapter connected to your PC or notebook computer before executing the Hi-Speed USB 2.0 DVI Converter setup or un-installation program.

•An AC power adapter is required for an external USB hub. The driver allows up to six Hi-Speed USB 2.0 DVI Converters on one PC.

•Connect the display device to the DVI connector of the Hi-Speed USB 2.0 DVI Converter and switch the display device on before plugging the converter into an available USB 2.0 port of the PC or notebook computer.

•Do not reboot the computer until all USB 2.0 DVI Converters are installed.

INTRODUCTION