Marantz DR6000 r ty u, Manual start recording, About Auto Track increment, Recording, English

ENGLISH

RECORDING

The numbers between parentheses refer to the fold-out.

ABC DEF GHI

1 2 3

JKL MN OPQ

4 5 6

				RST	UVW	XYZ
				7	8	9
				DISPLAY	SPACE	SCROLL
CD RECORDER DR6000					0
REC TYPE	REW	FF	STOP	PLAY/PAUSE
OPEN/CLOSE
					FUNCTION
Recordable
ReWritable				CDR		CD
	EASY JOG

POWER ON/OFF

					LEVEL	PHONES
DISPLAY	SCROLL				REC
	SOURCE	ERASE	STORE	CANCEL	FINALIZE	u
			MENU	DELETE
					PUSH ENTER
	e				r ty u	MENU/	ENTER
							CANCEL/
						STORE	DELETE

Manual start recording

Manual recording from external CD player.

1Make sure the disc is absolutely free of scratches and dust particles.

2Connect the cable from an external CD player to the CD- Recorder. (see INSTALLATION page 5 and 6.)

3Press SOURCE (7) repeatedly until the selected exter- nal source appears on the display (depending on the connection used):

➔	,		or		lights up and	,
		or		appears on the display.

About Auto Track increment

•When Auto Track is ON (default setting), track numbers will automatically be increased during recording.

•To switch off the Auto Track function you have to enter

MENU MODE.

If you wish to increase track numbers manually, press TRACK INCR(ement) on the remote control. For further instructions see MENU MODE.

ON (AUTO): The track increments are automatically taken over from the digital source material or after 2.7 seconds silence during analog recording.

OFF (MANUAL): Track numbers can be incremented manually by pressing TRACK INCR (ement) (54) on the remote control. (Minimum track length is 4 sec.)

•Track numbers cannot be changed after recording.

Note:

Auto track works only with Consumer Sources with a digital output signal according to the IEC 958 (consumer part) audio standard.

10

4With the recorder stopped, press REC TYPE (20) three times to enter the Manual Record standby mode.

➔ MANUAL starts to flash and the display shows

.

• If	message also flashes, the digital con-
nection is incorrect.

5Set the optimal recording level on the CD-Recorder. q Play the source first to set the optimal recording level on

the CD-Recorder.

w Rotate the EASY JOG (12) key until, on the Record/Play Level bar, all the white segments are alight, but the red segments do not light continuously during the loudest passages.

DIGITAL RECORDING : +6dB ~ –63dB

ANALOG RECORDING : 0dB ~ –63dB e Stop the source.

6To start recording, press 0 REC (13) on the CD-Re- corder and immediately start the source (from Stop- mode).

The track number and recording time left appear on the display.

•To record a 3-second silence at the start of a track, press 2/; PLAY/PAUSE (16) on the CD-Recorder before starting the source.

•To check the elapsed recording time, press DISPLAY (58) on the CD-Recorder. (This can also be done dur- ing the recording.)

7To stop recording, press 9 STOP (17, 68).

•If 9 STOP (17, 68) was pressed within 3 seconds af- ter 0 REC (13), no recording will take place.

•To interrupt recording, press 2/; PLAY/PAUSE (16)

or ; PAUSE (63).
After recording the display will show	for sev-
eral seconds.

Important:

If you want to play the recorded CD-R disc on any regular CD player, it must first be finalized. See finalizing discs.

Finalized CD-RW discs play only on CD-RW compatible CD players.

DR6000(U)_Eng_P01-10.p65 10 8/7/00, 1:35 PM