Marantz DV-12S1 COMP VIDEO setting, AUTO P OFF setting, REMOT CODE setting, English, Example

ENGLISH

COMP VIDEO setting

Select COMP VIDEO, then press ENTER.

Move the cursor control joystick down to select the type of COMP VIDEO you want to set as follows.

(Example)

IN MENU *

INTERLACE

PROGRESSIV

* Factory setting

Press ENTER you want to set.

The menu select is set.

• See page 37 for more information.

Note

COMP VIDEO setting

You only need to set this FL menu if you’re using an NTSC TV/monitor connected via the component video outputs of this player. This player can output NTSC video as a standard interlaced signal (the INTERLACE setting), or as a non-interlaced, or progressive scan signal (the PROGRESSIV setting).

If your TV/monitor is compatible with progressive scan video, set this setting to either PROGRESSIV or IN MENU. When set to IN MENU, you can use the on-screen Setup menu to switch between progressive and interlaced video output.

If your TV/monitor is not progressive scan compatible, you will not be able to see any picture if this player is set to output progressive scan video. In this case, set the setting to INTERLACE to restore the picture (page 37).

AUTO P OFF setting

Select AUTO P OFF, then press ENTER.

Move the cursor control joystick down to select the type of AUTO P OFF you want to set as follows.

(Example)

ON 30 MIN *

OFF

* Factory setting

Press ENTER you want to set.

The menu select is set.

•The standby mode is automatically selected to save power if the player is left in the stop mode for about 30 minutes.

REMOT CODE setting

Select REMOT CODE, then press ENTER.

Move the cursor control joystick down to select the type of REMOT CODE you want to set as follows

(Example)

DVD 1 *

DVD 2

* Factory setting

Press ENTER you want to set.

The menu select is set.

•The DVD player support two remote control codes: DVD 1 and DVD 2.

•Set the remote control code of the Remote Control to the same setting.

•See page 13 for more information.

24