Marantz PD4293D Setting the time for “INVERSE”, Once the setting is completed, Orbiter, Inverse

5.Once the setting is completed...

Press the EXIT button to return to the FUNCTION menu.

To exit the main menu, press the EXIT button twice.

Information

⬛PLE

AUTO .............. The brightness of the screen is

adjusted automatically to suit the picture quality.

LOCK .............. The brightness level is set to

minimum.

⬛ORBITER

OFF	Orbiter mode does not function.
ON	The picture moves around the screen
	intermittently.

⬛INVERSE

OFF	Inverse mode does not function.
ON	The picture is displayed alternately
	between positive image and negative
	image.
	You can set the time by pressing the
	PROCEED button while “ON” is set.
WT	The entire screen turns white.
	You can set the time by pressing the
	PROCEED button while “ON” is set.

⬛SCREEN WIPER

OFF	Screen wiper mode does not function.
ON	Repeatedly moves the white vertical
	bar from the left end of the screen to
	the right end at a constant speed.
	You can set the time by pressing the
	PROCEED button while “ON” is set.

⬛Restoring the factory default settings

Select “RESET” from the function menu. Note that this also restores other settings to the factory defaults.

*Only the PLE and ORBITER can be adjusted when a RGB signal is connected.

Setting the time for “INVERSE”

Set the “INVERSE” or “WHITE” display time and the “WAITING TIME”.

Example: Setting so that the INVERSE mode starts in 30 minutes and proceeds for one and a half hours.

Perform Steps 1-2 on Page 30, then

3.Use the ▲ and ▼ buttons to select “INVERSE”, then use the ◀ and ▶ buttons to select “ON”.

L O N G L I F E

PLE	:	AUTO
ORBITER	:	OFF
INVERSE	:	ON
SCREEN WIPER	:	OFF

SEL. PROCEED OK EXIT RETURN

4. Press the PROCEED button.

The “INVERSE/WT” screen appears.

I N V E R S E / W T

WORKING TIME :ON

SEL. ADJ. EXIT RETURN

5.Adjust the time using the ◀ and ▶ buttons and the ▲ and ▼ buttons.

The mode switches as follows each time the ◀ or ▶ button is pressed.

I N V E R S E / W T

WORKING TIME	:	1H
	:	30M
WAITING TIME	:	0H
	:	30M

SEL. ADJ. EXIT RETURN

The 1st line of the “WORKING TIME”:

→ON or 0H ↔ 1H ↔ 2H ↔ 3H ↔ ... ↔ 12H ←

*The “WORKING TIME” (minutes) and “WAITING TIME” cannot be set when the “WORKING TIME” is “ON”.

31