SETTING UP
Connecting Microphones
Connect microphones as shown below.
You can connect two microphones for stereo to the MIC/ LINE L and R (XLR) jacks.
Alternatively, you can connect just one microphone (for mono recording or dual level mono recording) to the MIC/LINE IN L jack.
MIC (L)
MIC (R)
R
L
Notes
•Take care not to connect or disconnect microphones while recording. This may result in unwanted sounds in the recording.
Connecting Analog
Components
The following illustrations show you how to connect analog audio components for recording or playback.
To record from analog audio components
Connect the source component’s analog line output jacks to the PMD690's MIC/LINE IN (XLR) jack.
MIXER, etc.
LINE OUT
R
L
ENGLISH
Powering the microphone(s)
This unit can supply +48 V of phantom power to the connected microphone(s). If your microphone(s) require phantom power, set PHANTOM +48V to ON.
Notes
•Phantom power is only applicable to condenser microphones. See the instruction manual of your microphones if phantom power is required.
•Do not use phantom power in combination with dynamic microphones to avoid damage to the unit or the microphones.
•You can also compensate for different microphones and/or environments. (See “ANC” and “MIC ATTENUATION” on page 14 for details.)
To output analog audio signals to another audio component
Connect the LINE OUT (RCA) jack on the PMD690 to the analog input on the destination component.
MIXER, TAPE DECK, etc.
LINE IN
R
L
7