/0 Code Setup
.:. Setting 10 code
Ex.) Set to
Remote control unit
Press and hold SET, then
Press
Rear panel of the unit
,
I | @ |
|
|
| SP, |
| ZONE' | , | |||
|
|
| R |
| |
| flDlOT'e COHTl'IOl. | ID | @ |
| @ |
:) | @w | SELECTOR |
| ||
| @©2.~ | is |
| ||
|
|
| 0 | 0 |
|
" | 1 - |
| @ |
Set to "1",
The ZS5300 system can be expanded up to 3 units.
When using 1 unit alone, set the 10 switch on the rear panel to "1",
To set the remote control unit to the 10 number of the unit, follow the procedure below.
1.Press the SET button and hold it, then press the
2.This remote control unit has been set as
3.When the batteries are replaced, the unit defaults to the factory setting of
Note:
This is important, because if you have changed 10 numbers, you will have to reset the 10 number when the batteries are replaced.
*Oefault setting for both the remote control unit and the unit is
8