Maretron M001101 user manual Table of Contents

®

			Table of Contents
1	General			1
	1.1	Introduction		1
	1.2	Firmware Revision		1
	1.3	Features		1
	1.4	Quick Install		1
2	Installation		............................................................................................................................	2
	2.1	Unpacking the Box		2
	2.2	Choosing a Mounting Location		2
		2.2.1 Mounting Location When Used With Analog Gauge(s)		2
		2.2.2 Mounting Location When Used Without Analog Gauge(s)		3
	2.3	Connecting the RAA100		4
		2.3.1 Connecting Attached Gray Cable to Analog Gauge or Rudder Sender		4
			2.3.1.1 Connecting Attached Gray Cable to Analog Gauge	5
			2.3.1.2 Connecting Attached Gray Cable to Rudder Angle Sender	5
		2.3.2 Connecting to NMEA 2000® Interface		5
3	Configuring the RAA100			6
	3.1	Configuring Rudder Instance Number		6
	3.2	Configuring Operating Mode		7
		3.2.1 Configuring Analog Gauge Resistance		7
			3.2.1.1 Power Terminal to Sensor Terminal Resistance Measurement	7
			3.2.1.2 Ground Terminal to Sensor Terminal Resistance Measurement	7
	3.3	Standard Sender Selection or Custom Calibration		8
		3.3.1	Standard Sender Selection	8
		3.3.2	Custom Calibration	8
4	Maintenance			8
5	Troubleshooting			9
6	Technical Specifications			10
7	Technical Support			11
8	Maretron (2 Year) Limited Warranty			12

Revision 1.0 Page iii