Moving the Nº33H
Product Registration
4.Use a socket wrench to remove:
•The four
•The two
Please read and understand these instructions before attempting to move the Nº33H from the shipping crate base.
Note:
Protect delicate floor surfaces before moving the Nº33H off the crate and onto the floor.
1.Position two people at the front of the Nº33H to support its weight; a third person may be needed to hold the base of the crate in place while the Nº33H is moving.
2.When all people are in position, carefully slide the Nº33H off of the crate’s base and onto the floor.
As the front of the Nº33H clears the front edge of the crate, the two people positioned at the front of the Nº33H must
begin to support its weight. To do this, use the “handle” built 3 into the sculpted faceplate (located just above the Mark
Levinson logo) or the front heat sinks.
3.Continue to slide the Nº33H forward until its center section clears the front edge of the base. Then lower the front of the Nº33H to the floor.
At this point, the floor should support the front of the Nº33H and the base of the crate should support the rear.
4.Position two people at the rear of the Nº33H; a third person may be needed to slide the base of the crate out from underneath the Nº33H.
5.Grip the rear heat sinks. Then lift the rear of the Nº33H, leaving the front supported by the floor.
6.When the rear of the Nº33H is lifted, slide the base of the crate out from underneath the Nº33H, then carefully lower the rear of the Nº33H to the floor.
Please register your Nº33H Monaural Power Amplifier within 15 days of purchase. Register online at www.marklevinson.com or complete and return the included product registration card. Retain the original, dated sales receipt as proof of warranty coverage.
