OPERATING INSTRUCTIONS POWERMID®DUAL POWER
1. Place the (flat) PowerMid® Receiver in the room that contains the audio / video equipm
you want to control. Hook up the supplied adaptor and plug it in a 230V wall socket. If
there’s no socket close enough, you can also place 4 ‘C’-cell batteries in the battery
compartment. Please check if the polarity is correct. The receiver operates max. 5.000 hou
on four C-size Alkaline batteries. To save batteries, you can switch off the device by sliding
the switch at the bottom to ‘OFF’.
Make sure the front of the unit is facing your IR controlled A/V equipment, and place the
antenna upwards. Make sure the unit is located maximum 6 meters away.
2. Plug the PowerMid® Transmitter into a
230V socket in the room from you want to
remote control your equipment from. Make
sure that the front side (with the Marmitek-
logo) is pointed towards you, maximum 5
meters away. Fully extend the antenna.
3. Point your remote control at the
PowerMid® Transmitter. It receives the IR-
signals from your remote control and transmits
these to the PowerMid® Receiver. The PowerMid® Receiver then re-transmits these infrare
signals to your TV, VCR, stereo, etc. Add more Transmitters (art. no. 09481) to use your
remote controls in several rooms. Add more
Receivers (art. no. 09482) to control equipment
in different rooms.
When it’s not possible for you to place the
Receiver in front of your equipment (for
example when it’s behind cabinet doors), you
can use the supplied wired Infrared LEDs RX
570. Plug the extender into the rear of the
receiver, and attach one of the black IR
POWERMID DUAL POWER
PowerMid Receiver
PowerMid Transmitter
OFF ON
Infrared LEDs
manual_powermid_dualpower 05-06-2003 10:38 Page 3