Marmitek manual Sample 1. Program the Marmitek X10 address E4, MICROMODULE AWM2

For programming the Marmitek X10 address and options you will be able to use any Marmitek X10 controller or remote control. For the following explanation we used a Marmitek 8-in-1 remote control to program the preferred settings (When you use an RF remote control like the Marmitek 8-in-1, then a TM13 Plug-in Transceiver is required to convert the RF signals to the X10 commands on the power line).

Sample 1. Program the Marmitek X10 address E4:

•Setup your remote control (see manual 8-in-1) and the TM13 transceiver to house code E.

•Start with the MicroModule in setup mode.

•Press the Marmitek X10 button (marked with the symbol of a house) of the 8-in-1 remote control and then press button 4.

•Press the "ON" button 2x (= channel+).

•The MicroModule responds by blinking the LED twice.

•The address E4 is programmed.

Sample 2. Program the function "All Units Off"

•Make sure you program the required Marmitek X10 address first!! (e.g. E4).

•Leave the remote control and the TM13 Transceiver on HouseCode E or set it to the right HouseCode.

•Start with the MicroModule in setup mode.

•Press button marked with "All Units Off" 2x (= mute).

•The MicroModule responds by blinking the LED 8x.

NOTES:

•When you program the MicroModule, always program the address first the optional function second.

•If the MicroModule receives a new address during setup mode, the optional functions will be automatically reset to the factory defaults.

MICROMODULE AWM2 9