•Install the wall switch at its original place after the MicroModule is programmed.
Programming
WARNING: DO NOT FORGET TO TURN ON THE MAIN MASTER SWITCH PRIOR TO PROGRAMMING.
Activate the setup mode.
The following steps have to be taken to start the setup procedure for programming the MicroModule:
•Press the setup (prog.) button for at least 3 seconds (see figure 5). The LED should stay on after releasing the setup button.
•Warning! The MicroModule will leave the setup mode if it doesn’t receive any commands within 60 seconds.
Exit setup mode
•Press the setup button once shortly; The red LED will turn off now. You can also wait for at least 60 seconds so that the MicroModule will exit the setup mode automatically.
MICROMODULE AWM2 | 7 |
