Marmitek user manual Registering The Repeater To The Control Panel, RP835 & PK836

Connect the Programming Keypad (PK836) to the Programming Keypad (PK836) connector.

Note: The Programming Keypad (PK836) is not able to operate on battery power only.

8.Test the repeater from the required mounting location before permanently mounting the unit.

9.Mount the base to the wall using four screws and replace the front cover.

When the tamper switch is open, the bi- color LED provides indication regarding repeater transmission and reception as an aid during the installation procedure

–see Table 1. When the tamper switch is closed, the bi-color LED provides indication regarding power status – see Table 2.

LED Indication	Description
Flashing Green	Signal Reception
Flashing Red	Signal Transmission
Table 1: LED Indication (Tamper Open)
LED Indication	Description
Steady Green	AC & Battery OK
Flashing Red	AC Loss
Flashing Orange	Low Battery

Table 2: LED Indication (Tamper Closed)

REGISTERING THE REPEATER TO THE CONTROL PANEL

For the control panel to recognize the repeater, you must register the repeater to the control panel.

To register the repeater to the control panel:

1.Set the control panel to Registration mode as follows:

•From the Programming menu, select Devices, Repeaters [914].

•Select the repeater you want to register (1-4).

•From the repeater’s sub-menu, select Register [#1].

2.Send two Status transmissions from the repeater as follows:

•On the Programming Keypad (PK836),

press until 5. STS Transmit appears on the display.

•Press 9.

•Press 9 again.

Figure 3: LCD rogramming

Keypad (PK836)

RP835 & PK836 4