Something not working
Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer.
Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is in guarantee.
...a flashing fault code appears
The dishwasher will not start or stops during operation.
The intervention of an alarm is indicated by:
-continuous flashing of the start/cancel indicator light,
-a combination of flashing and pauses of the End indicator light (as described in the chart).
Open the door and carry out the following suggested corrective actions.
Fault code / malfunction | Possible cause | Solutions | ||
|
|
|
|
|
- continuous flashing of the | The water tap is blocked or furred with | Clean the water tap. | ||
"start/cancel" indicator light | limescale. |
|
| |
|
|
|
|
|
- 1 flash of the "End" indicator | The water tap is turned off. | Turn the water tap on. | ||
light |
|
|
|
|
| The filter (where present) in the threaded hose | Clean the filter in the threaded hose | ||
|
| |||
The machine does not fill with |
| fitting at the water inlet valve is blocked. | fitting. | |
|
|
|
| |
| The water inlet hose has not been correctly laid | Check the water inlet hose connection. | ||
water. | ||||
|
| or it is bent or squashed. |
|
|
|
|
|
|
|
- continuous flashing of the | The sink spigot is blocked. | Clean out the sink spigot. | ||
"start/cancel" indicator light |
|
|
| |
|
|
|
| |
- 2 flashes of the "End" indicator | The water drain hose has not been correctly laid | Check the water drain hose connection. | ||
light | or it is bent or squashed. |
|
| |
The dishwasher will not drain. |
|
|
| |
|
|
|
|
|
Once these checks have been carried out; close the door and press the start/cancel button. The programme will continue from the point at which it was interrupted. If the fault code reappears contact your local Service Force Centre.
For other combinations of fault codes not described in the above chart, please contact your local Service Force Centre.
...there are problems when operating the dishwasher
Malfunction | Possible cause | Solutions | ||
|
|
|
| |
|
| The dishwasher door has not been properly | Close the door. | |
The programme does not start | closed. |
| ||
|
| |||
The main plug is not plugged in. | Insert the mains plug. | |||
|
| |||
|
|
|
| |
|
| The fuse has blown in the household fuse box. | Replace the fuse. | |
|
|
| ||
There is a whistling noise during | The whistling is not a cause for concern. | Use a different brand of detergent. | ||
washing |
|
| ||
|
|
|
| |
15
