Marmitek PK836, RP835 user manual Installation

INSTALLATION

1.Register all wireless devices to the ProGuard800 control panel as explained in the ProGuard800 installation manual.

2.On the control panel, define the detection devices that are intended to transmit via the repeater as follows:

•From the Programming menu, select Devices, Zones [911].

•Select the zone you want to program (1-32).

•From the zone’s sub-menu, select Repeater [#9].

•Select “Use Repeater”.

Note: It is not necessary to define, at the control panel, the keypads and keyfobs that are registered to the repeater.

3.Open the RP835’s plastic housing. To do so, remove the two cover screws and lift the front cover away from the base.

Antenna

Connector

Upper

Mounting

Hole

Transmitter

Receiver

Power Input

Terminals

AC Power

Protection Fuse

Lower

Mounting

Hole

Wiring

Hole

Figure 2: RP835 (cover removed)

LED Indicator

Flash

Programming

Programming

Keypad (PK836)

Backup

Battery Pack

Battery Connector

Lower

Mounting

Hole

Tamper

Switch

4.Connect the antenna provided to the antenna connector.

5.Connect the backup battery pack to the Battery connector.

6.Connect a 9VAC or 12VDC transformer to the Power Input terminal block (polarity is not important).

7.All registration and test functions, described in the following sections, are performed from the LCD Programming Keypad (PK836) shown in Figure 3.

3 © MARMITEK