Martin Fireplaces 2518 user manual Blackout / Standby

TO CLEAR AUTO-START

This procedure clears the memory lock and auto-start functions: to reset the memory

lock see page 22.

1.Turn off the controller. In tandem mode, turn off the top controller.

2.Turn on the controller and immediately press and hold the top 3 channel buttons until “ON” or “OF” is displayed.

3.Repeat.

BLACKOUT / STANDBY

In blackout mode, the controller blacks out lights by sending DMX value 0 on all channels.

In standby mode, there is no DMX output from the controller. Fixtures will behave differently when the DMX signal stops: some will blackout, some will keep their last look, and some will run in stand-alone mode. Standby mode uses very little current and is recommended whenever the controller is not being used for extended periods.

TO BLACKOUT ALL FIXTURES

1.Press [Blackout]. The display flashes.

2.Press [Blackout] again to resume operation.

TO TOGGLE STANDBY MODE

1.Press and hold [Blackout] until the display clears.

2.To return to normal execution, press [Blackout] again. Power-on commands may be executed immediately after pressing the button.

17