VENT-FREE

FIREPLACE SYSTEMS

INSTALLATION AND

OPERATING INSTRUCTIONS

MODEL: 33ISDG

Natural Gas or Propane/LPG

Control Type: Milli-Volt and T-Stat

This appliance may be installed in an aftermarket, permanently located, manufactured (mobile) home, where not prohibited by local codes.

This applicance is for use only with the type of gas indicated on the rating plate. This applicance is not convertible for use with other gases.

This is an unvented gas-fired heater. It uses air (oxygen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided. See page 9.

WARNINGS

If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

READ AND SAVE THESE INSTRUCTIONS

Page 1
Image 1
MartinLogan operating instructions Model 33ISDG, What to do if YOU Smell GAS, Read and Save These Instructions