MartinLogan 6 user manual Removing the Logo Badge

2Affix the wall pads to the back of the speaker at the lower contact points (fig. 6).

3Locate mounting location using a level and the installation template.

Note: HORIZONTAL installation requires the use of TWO wall brackets.

Note: VERTICAL installation requires the use of ONE wall bracket.

4 Mark the pilot hole locations.

5Drill the pilot holes using a 1/8-inch drill bit. If a pilot hole DOES NOT hit a stud, widen that pilot hole using a 1/4-inch drill bit and install a wall anchor at that location (fig. 7).

6Using the 1-inch Phillips screws, mount the wall bracket(s) as shown (fig. 7).

7Hang the speaker, guiding the wall mount bolt into the wall bracket keyhole(s).

REMOVING THE LOGO BADGE

To remove the logo badge gently pull it away from the speaker grill (fig. 8).

Fig. 7

Fig. 8

6