REGULATOR TO GAS CYLINDER VALVE CONNECTION
|
| TYPE 1 CONNECTION | |
| COUNTER | TO GAS CYLINDER | |
CLOCKWISE | Inspect the hose before each use. | ||
CLOCKWISE | |||
|
| If there are signs of wear, cuts or | |
|
| leaks replace turkey fryer hose & | |
ON | OFF | regulator with part 903070006. |
Soapy Water Test Warning and Procedures
•The Soapy Water Test must be performed each time gas cylinder is connected to appliance or each time the appliance is used.
•The Soapy Water Test must be performed outdoors in a
•When performing the Soapy Water Test, always keep fryer away from open flames, sparks, or lit cigarettes.
•This Outdoor Gas Turkey Fryer is designed to operate with propane gas only. This product will not operate with natural gas.
•Never use an open flame to test for gas leaks.
•Always remove any cookware from turkey fryer stand when performing the Soapy Water Test.
REGULATOR CONTROL VALVE OPERATIONS
PROCEDURE:
1.Remove any cookware from your fryer stand.
Burner, Hose, Regulator and
Cylinder Valve
ONOFF
COUNTER
CLOCKWISE CLOCKWISE
REGULATOR CONTROL FLAME ADJUSTMENT
The regulator control valve is used to adjust the burner flame. Turning the control knob clockwise slowly will increase the burner flame and counter clockwise to decrease and
shut the burner flame off.
2.Turn regulator to OFF position, and turn the gas cylinder valve to the OFF |
position. |
3.Prepare your soapy water solution by combining (1) one part dish washing |
liquid with (3) three parts water to test for the possibility of any gas leaks in the |
hose or connections to regulator and the regulator connection to gas cylinder. |
Apply soapy water solution to the gas cylinder valve, regulator and along the |
hose to the burner. |
Regulator Control Valve
Adjust air shutter to the burner until the
burner flame is as blue as possible
YELLOW
BLUE 
CORRECTINCORRECT
FLAMEFLAME
Type 1 Regulators will have a hook as shown.
The Regulator Hook is used to keep the regulator off the ground when removed from the LP cylinder.
Attach to appliance as shown.
4.Turn gas cylinder valve ON (regulator control valve should be in the OFF |
position) and observe gas cylinder valve for bubbles. DO NOT LEAVE GAS ON |
FOR MORE THAN 12 SECONDS. If bubbles appear, stop, turn gas cylinder |
OFF, and retighten the fitting. Repeat test. |
5.When the gas cylinder has been tested, follow timer operation instructions on |
page 10. DO NOT LIGHT BURNER. Open the regulator control valve one full |
turn and check for bubbles at regulator control valve, along the entire length of |
hose and at the connection to the burner . DO NOT LEAVE GAS ON FOR |
MORE THAN 12 SECONDS. If soapy mixture starts bubbling, gas is leaking |
through the connection or hose. Turn the regulator valve OFF and then the gas |
cylinder OFF and retighten the connection that is leaking gas. After test is |
complete, and there are no leaks, wait a minimum of 5 minutes for gas fumes |
to diminish before lighting fryer. |
6.Once testing is complete, press power button on timer to stop gas flow.
Burner, Hose and orifice Connection
Bubbles in Soapy Water Test
DURING ANY PORTION OF THE SOAPY WATER TEST, IF BUBBLES CONTINUE TO APPEAR, STOP, DO NOT USE THE APPLIANCE AND CONTACT YOUR LOCAL PROPANE DEALER OR MASTERBUILT AT
NOTE: USE A 20 LB (9KG) CYLINDER WITH A PROTECTIVE COLLAR WITH THIS APPLIANCE. ONLY CYLINDERS MARKED “PROPANE” MUST BE USED.
9 | 14 |
