WARNING
•The use of alcohol, prescription or non prescription drugs may impair the consumer’s ability to properly assemble or safely operate the appliance.
•Do not obstruct flow of combustion and ventilation. Keep the ventilation opening(s) of the cylinder enclosure free and clear of debris.
•The installation of this appliance must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/ NFPA 54, Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58 or CSA B149.1, Natural Gas Installation Code
•The
DANGER
Gas Cylinder Storage, Placement and Filling:
•Do not store a spare
•Never fill the cylinder beyond 80 percent full. Over filled cylinders can
release gas.
•If you smell, hear or see gas escaping immediately get away from the gas cylinder and call the Fire Department. a fire causing death or serious injury may occur.
•Place a dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the dust cap on the cylinder valve outlet that is provided with the cylinder. Other caps or plugs may cause leaks.
For Your Safety
Gas Cylinder Storage and Appliance Check:
Cylinders must be stored outdoors out of reach of children and must not be stored in a building, garage, or any other enclosed area.
Before each use check all nuts and bolts to be sure that they are tight and secure.
Before each use inspect gas hose for any signs of damage. Before each use preform soapy water test.
Our #1 Asked Question
When The Cast Iron Burner Burns Yellow or Not At All, What Do I Do?
If your burner does not burn, blows out, burns yellow, or there’s a flame inside the venturi, you need to check the burner venturi for any obstructions. Dirt dobers, spiders and other insects will build a nest inside the burner ventura blocking air and gas flow.
KEEP AIR SHUTTERS CLOSED AFTER EACH USE.
How To Clean
1.Remove the control valves from the burner.
2.Insert a small rod in the hole that the control valve was removed from.
3.Hold the burner up to a light looking into the hole that the valve was removed from to see any obstructions.
4.If burner has not cleared, flush with water.
5. Once the burner has been cleared, reassemble the burner. Follow steps on page 6.
When a flame occurs inside the ventura this is caused by a blockage and could cause damage to the hose assemble.
SAFE STORAGE & MAINTENANCE
•Before each use of appliance, check and clean burner/ventura tubes/hoses for insects and insect nests. A clogged tube/hose can lead to a fire beneath the cooker.
•Check regulator, hose, and burner parts, air shutter and ventura section carefully before and after each use for any sign of wear.
•ALWAYS turn gas OFF at gas cylinder valve prior to inspecting parts.
•DO NOT obstruct flow of combustion and ventilation. Keep ventilation opening(s) of cylinder enclosure clear of debris. Cylinder supply system must be arranged for vapor withdrawal. Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids.
•Coat cooker stand with cooking oil after unit has cooled.
•ALWAYS allow appliance to cool completely before handling.
•Before storing appliance, dispose of remaining coals and ashes into a noncombustible container.
•When appliance is not in use, gas must be turned off at supply cylinder.
•ALWAYS disconnect gas cylinder after using appliance.
•ALWAYS cover and store your appliance in a protected area.
•Cylinders must be stored outdoors out of the reach of children and must not be stored in a building, garage or any other enclosed area.
•Always store gas cylinder upright and in areas where temperatures won’t exceed 125°F, and Do Not store a spare cylinder on, or near, your cooker stand, or place connected gas cylinder under cooker stand. Always keep gas cylinder 20 inches away from cooker stand.
•Indoor storage of appliance is permissible only if cylinder is disconnected and removed.
•If any rusting occurs, use steel wool to clean or buff affected area.
•The exterior of appliance may be touched up using a high
5 | 10 |
