6 . LOADING THE PHONE SOFTWARE & DRIVERS
As you will be required to connect your MM-5100 to your computer and a power source you must attach an antenna to MM-5100 NOW. This must be done before ANY power is connected to the modem.
NOTE: The MM-5100 can be powered solely through the USB connection to your PC, however the maximum power draw available on USB is 500mA. Therefore USB power would only be suitable where the RSSI signal strength LED on the modem is ON solid. If the RSSI LED is flashing we recommend you use alternative power source such as the optional 240vAC to 12vDC plug pack.
During the following steps you will: Load UI software from CD supplied Supply power to MM-5100
Connect MM-5100 to PC via the supplied Serial or USB cable Load appropriate drivers from CD supplied
Step 1: Load the CD
Insert the supplied CD into your CD drive. It should auto-run without intervention. If not, locate the CD drive on your computer, then double click on Setup.exe.
Double click setup.exe to start the installation
This will start the installation.
MM-5100 Windows Setup Manual 090803 NZ | Page 9 of 44 | 4/09/2003 |
