MM6854/64 Dual Band GSM Data Modem
5.1.43 AT+CRLP – Radio Link Protocol parameters
This command lets you change parameters for the radio link protocol, used only for
Enter | Response |
| |
size>,<down window |
|
size>,<acknowledgement |
|
timer>,<retransmissions |
|
attempts>,<reset |
|
| |
time> |
|
AT+CRLP? | Displays the current settings. |
AT+CRLP=? | Displays the supported settings. |
| Notes: None |
| Result codes: |
| OK |
| ERROR |
5.1.44 AT+CSCA – Service centre address
This command shall be used to indicate to which service centre the message has to be sent.
The modem has no default value for this address. If a SMS is sent without having indicated the service address, an error will be generated.
Enter | Response |
AT+CSCA=”<sca>” |
|
Where <sca> | GSM 04.11 RP SC address |
AT+CSCA? | Displays the current value. |
| Notes: None |
| Result codes: |
| OK |
| ERROR |
| Message service failure result codes |
5.1.45 AT+CSDH – Show test mode parameters
This command is used to determine if a detailed header information is shown in text mode result codes.
Enter | Response |
AT+CSDH=0 | Disable header information. |
AT+CSDH=1 | Enable header information |
AT+CSDH? | Displays the current value. |
AT+CSDH=? | Displays the supported values |
| Notes: None |
| Result codes: |
| OK |
| ERROR |
| Message service failure result codes |
ME 820047 | Issue 1.0 |
Page 26 | 03/00 |