MaxTech NX-16 manual Card Configuration

6.Carefully install the adapter by firmly press- ing the card into the slot you have chosen, applying even pressure until the adapter is completely seated in the slot.

7.Fasten the retaining bracket with the screw from the slot cover. Make sure the adapter is properly aligned. Store the slot cover for future use.

8.Replace the computer cover and reconnect the power cord and all cables.

9.Attach the network cable to your adapter.

2.3Card Configuration

The following configuration options are available in the SETUP program:

•Auto Configuration

•Set Configuration

The Auto Configuration option allows automatic configuration when a Maxtech NX-16 Series network adapter is installed in the PC. This option will select valid I/O and IRQ addresses when a conflict is detected with other adapter cards installed in your PC.

The Set Configuration option allows selection of operating parameters such as I/O Base Address, IRQ selection, Transceiver, and Boot ROM Address.

The default configuration parameters are:

I/O Base Address:	0300H
IRQ Line:	3
Transceiver:	Twisted Pair (BNC on
	NX-16B)

Boot ROM Address: Disable

4