information.

To run SETUP.EXE, insert the driver diskette into a disk drive.

From the DOS prompt, change to that drive by typing A: (or B:) and pressing Enter.

Type \SETUP at the DOS prompt and press Enter. This will start the program.

2.4.1 View Current Configuration

Select View Current Configuration to see the current adapter settings. This option will show the settings for:

Ethernet Address

Medium Type

Full Duplex

I/O Base

Interrupt

Boot ROM Size

2.4.2 Set Up New Configuration

The Set Up New Configuration option allows you to change settings on the adapter. Your PC's BIOS should have automatically allocated the neces- sary I/O base address, interrupt, and Boot ROM address (if needed) to the adapter. SETUP will not allow you to change any resources which are allocated by the BIOS. It does allow the user to change the following settings:

Medium Type

Full-Duplex Function

Boot ROM Size

Medium Type has four options: A) 10 BASE-T, TP/CX Auto-Detect for 10Base-T(RJ-45) or 10Base-2 (BNC) networks (automatically detected),

B)10 BASE-T Link Test Disabled for twisted pair networks, C) 10 BASE-5 for 10Base-5 (this selec- tion cannot be used with this card), and D) 10 BASE-2 for coaxial networks.

6

Page 7
Image 7
MaxTech NX-32PCI manual Set Up New Configuration, Medium Type Full-Duplex Function Boot ROM Size