Installation
Figure 3-7Mounting Screw Clearance for the Maxtor Quickview 300 Hard Disk Drives
CAUTION: The PCB is very close to the mounting holes. Do not exceed the specified length for the mounting screws. The specified screw length allows full use of the mounting hole threads, while avoiding damaging or placing unwanted stress on the PCB. Figure 3-7specifies the minimum clearance between the PCB and the screws in the mounting holes. To avoid stripping the mounting hole threads, the maximum torque applied to the screws must not exceed 8 inch-pounds. A maximum screw length of 0.25 inches may be used.
Quickview 300 80/100/120/160/200/250/300GB PATA | 3-13 |
