Maxtor 4 CH Digital Multiplex Recorder user manual Md-Nvm, Area, Motion Record

MOTION

1. SEN (Sensitivity)

Sets the sensitivity of the Pixel-based Motion Detection feature from 1fo 70.

2. MD-NVM

Sets the number of targets in which Motion must occur in order to trigger an Alarm (from 1-99 target areas).

Note: MD-NVM cannot be less than the number of targets set in the AREA.

3. RE

Sets the Reference image to which the current screen is compared (from 1-99). For example, the value 64 would compare the current image to the 64th previous screen image.

(MENU)

TIMER CAMERA RECORD ALARM DWELL PIP MOTION DISPLAY REMOTE USER SYSTEM EVENT

4. DET

The motion detection on each channel setup can be turned to ON or OFF individually.

5. AREA

Press the ENTER button on this option to set the Pixel-based Motion Detection Area for each channel. Green targets represent the Motion Detection Area(Figure 1-2), and Purple targets represent motion currently taking place (Figure 1-3). To modify the Motion Detection Area, use the following controls:

+: turns the selected target ON/OFF.

▲▼ ◄ ► : navigates between targets

-:turns all targets on the screen ON/OFF

Zoom: turns all targets in the selected row ON/OFF

(MOTION)

SEN MD-NVM RE DET

CAM1 70 03 64 ON AREA

CAM2 70 03 64 OFF AREA

CAM3 70 03 64 ON AREA

CAM4 70 03 64 ON AREA

MOTION RECORD : ON

DAY START END

DAILY 00 : 00 00 : 00

6. MOTION RECORD

When the DET setting is “ON”, you can set up the MOTION RECORD function,

1.Select “ON” to set up the motion trigger record: It can automatically switch to Record Mode. The motion detection will change the scanning sequence and shows on the monitor.

NOTE: The trigger recording time will depend on ALARM DURATION mode setting (Please refer to page.11 for ALARM DURATION) and it will record from the last trigger time. For example, when the alarm duration setting is 1 min, the recording time is from 9:00:00 to 9:01:00. If the motion detection trigged again at 9:00:40, the trigged recording time will from 9:00:00 to 9:00:40 and 9:00:40 to 9:01:40. The total recording time is 00:01:40.

2.Select ”OFF”: The screen still showsand if it is in record mode, the motion detection will change the scanning sequence.

For example : If the motion is detected on Camera #1, its recording & scanning sequence will be more frequently. The sequence will be as 1st, 2nd, 1st, 3rd, 1st, … 4th. And channel 1 will showon the screen. If 2nd camera and 3rd camera

both motion detection are activated, they will be scanning as 2st, 3rd, 1st, 2nd, 3rd, 4th, 2nd, 3rd, 1st, 2nd, 3rd, 4th … and vice versa. And CH2 & CH3 will show for a period of time which is same as Alarm Duration time.

15