INSTALLATION

1 Before You Begin

IMPORTANT – PLEASE READ!

Please read this Installation Sheet completely before installing the Maxtor hard drive. It gives general information for installing a Maxtor hard drive in a typical computer system.

If you don’t understand the installation steps, have a qualified computer technician install the hard drive.

Handling Precautions

Allow the hard drive to reach room temperature BEFORE installing it in your computer system.

Hard drives are sensitive to electrostatic discharge (ESD) damage.

Handle the drive by its sides. DO NOT touch the printed circuit board assembly.

NEVER drop, jar, or bump the drive.

DON’T connect/disconnect any drive cables when the power is on.

DON’T use any low-level formatting software on this drive.

System Requirements

IDE/AT interface

486 processor or higher

Operating System Requirements

For drives less than or equal to 8.4 GB: DOS 5.0 or higher

For drives larger than 8.4 GB:

Installing as Boot drive (Primary Master) requires full installation set of Windows 95 or higher (not upgrade).

Installing as non-Boot drive (Primary Slave, Secondary Master or Slave) requires that Windows 95 or higher be installed on the Boot drive.

Tools for Installation

The following tools are needed to complete the installation of your Maxtor hard drive:

A small Phillips head screw driver

Your computer user’s manual

Small needle-nose pliers or

Operating system software

 

tweezers

 

 

Drive Identification Information

Copy the following information from the label on the top cover of the Maxtor hard drive for future reference:

Model Number _____________________ Serial Number _____________________

Cylinders ______________ Heads _____________ Sectors _______________

HDA Uplevel ______________ PCBA Uplevel _____________ Unique Uplevel _______________

Capacity Barriers

Due to operating system limitations, DOS cannot access the full capacity of drives larger than 8.4 GB. The Microsoft Windows 95 operating system or equivalent (full installation), NOT a Windows 95 upgrade from DOS (Windows 3.1 or 3.11), is required to obtain the full capacity of any hard drive larger than 8.4 GB.

Protecting Your Existing Data

Periodicbackupofimportantdataisalwaysagoodidea.Wheneveryourcomputerison,thereisthepotentialforlosingdataonyourharddrive.Thisisespeciallytruewhenrunning disk utilities or any software that directly manipulates your files. Maxtor recommends that you make a backup copy of the files on any existing hard drives. If required, this datamaythenbecopiedtotheMaxtorharddriveafterithasbeeninstalledinyourcomputer.Refertoyourcomputeruser’smanualfordetaileddatabackupinstructions.

4 – 4

Page 25
Image 25
Maxtor 6800 manual Handling Precautions, System Requirements, Tools for Installation, Drive Identification Information