Maxtor SLD240 Connect to a LAN Hub Intranet, All other Windows systems, Setting the DVR

All other Windows systems:

1.Open the START menu and click on the RUN tab.

2.In the RUN menu, type “winipcfg”.

3.The resulting window should display the IP address of your system. Please take note of this address.

Setting the DVR

1.On the DVR, press the SETUP button and select the COMMUNICATION tab.

2.In COMMUNICATION, select NET IP, then SET.

3.In the NET SETTING window, enter the IP address you identified on your computer in the step above for all numbers except the last 3 digits. You may assign these last 3 digits for any number between 001 and 255 (xxx.xxx.xxx.001 to xxx.xxx.xxx.255) but may not be identical to the last 3 digits of your computer’s IP address. It is not necessary to change the MASK or GATEWAY settings.

4.Press enter to save these changes.

To view the DVR from your computer, refer to Section 11.1 or 11.3.

9.1.2 Connect to a LAN Hub (INTRANET)

	FROM MUX
VIDEO	MAIN MONITOR
		AUDIO	RS-485
	I N	I N
		ETHERNET	RS-232
		10/100
		OUT
	OUT
TO	TO		ALARM	I / O
MUX'S VCR IN	M O N I T O R				DC12V

RJ-45

NOTE: When connecting to a LAN, each connected DVR must be assigned a unique IP, which must be in the same class type as your network address. IP addresses are written as four sets of numbers separated by periods; for example, 192.168.0.1 Therefore, if the connected network is identified as Class C, for example , the first three sets of numbers of the DVR IP address must be the same as the network address. If the connected network is identified as Class B, the first two sets of numbers of the DVR IP address must be the same as the network address. If you have any questions regarding these settings, please contact a qualified MIS professional or your ISP.

51