Maytag 2206679 Water USE, Start Your Maytag Neptune TOP-LOAD Washer, Estimated Time Display

OPERATING INSTRUCTIONS

Step 7

START YOUR MAYTAG® NEPTUNE® TOP-LOAD WASHER

•Add detergent and additives to the dispensers (See pages 7-8).

•Close the lid.

•Press the Start/Pause pad.

NOTES:

• When the cycle is complete, the Locked light will go out.The lid will open easily. Do not attempt to open the washer when the Locked light is illuminated.To add a forgotten item, see page 3.

• When the washer is started after a pause, there will be a pause of up to 20 seconds before continuing the cycle.

• Pressing Off cancels the cycle and stops the washer.

• Some cycles are designed to tumble then pause.This is normal.

ESTIMATED TIME DISPLAY

When setting the cycle and pressing Start/Pause, the display will show the estimated minutes remaining in the cycle.The estimated time remaining may fluctuate to better indicate the wash time left in the cycle.

INDICATOR LIGHTS

Locked – Lights whenever the lid of the washer is locked.The lid can be unlocked by pressing the Start/Pause pad to pause the washer.

Pad Indicator Lights – The indicator lights next to the pads will illuminate when the pad is selected.

Cycle Status Lights – The Cycle Status lights will illuminate to indicate where the washer is in the selected cycle.

WATER USE

The amount of water used will vary with each load. Since the Maytag® Neptune® Top-Load washer is designed for high-efficiency, you will notice much less water in the tub than a conventional washer.This is normal.The Maytag® Neptune® Top-Load washer uses an adaptive fill system to automatically provide the appropriate amount of water for efficient cleaning performance and conservation of water and energy. Fill time will vary depending on water pressure.

6