Rinse aid
Pour in rinse aid
Drying proceeds more quickly if you use rinse aid.
Machines with indicator on the panel 
When the rinse aid has run out and more is needed, the rinse aid symbol on the panel lights up*.
To fill with rinse aid:
1.Turn and lift up the cover of the rinse aid compartment to the right of the dispenser. This is where you top up and set the amount of rinse aid to be dispensed in each wash.
2.Carefully pour in rinse aid up to the knob for dosage setting.
Alter dosage if required. Do not forget to close the cover.
*NB!
After filling there may be a short delay before the signal light goes out.
Machines with refill indicator
There is a refill indicator in the middle of the dispenser (see picture). If the refill indicator is totally black, there is sufficient rinse aid.
However, if the indicator has a more transparent appearance, you need to top up with rinse aid (see above).
Open
Refill indicator
Closed
Cover for rinse aid
Open by turning and lifting the cover!
Select dosage
The dispenser is usually set at 1= soft water. However, depending on the water hard- ness, it may be necessary to change the dosage.
Open the rinse aid cover . Here you will find the dispenser’s adjustment dial. Settings 1-
6:the harder the water, the higher the dos- age.
Where the water hardness exceeds 10-
12 odH you should use rinse aid with citric acid (acid rinse aid) if the dishwasher does not have a water softening filter. If the dish- washer has a water softening filter, dis- pense as for soft water.
Too much rinse aid can lead to the
Too much rinse aid can cause streaks on the dishes, while too little can result in water stains.
20
