Maytag 661S/W manual Installation, Suggestions for positioning the dishwasher, A. Built-in

Installation

Suggestions for positioning the dishwasher

The dishwasher can be built in, fully free- standing or semi-freestanding.

CAUTION!

Connection to electricity, water and drain- age must be carried out by a suitably quali- fied person.

A. Built-in

The dishwasher can be built in under a worktop with a working height of 820 - 870 mm. The width measurement must be at least 600 mm. For additional measurements, see picture.

Built-in installation

820-870

570 600

-230 175

50

	570
550	20
	820-
	870
	100-
	150

50-105

B. Freestanding

A freestanding dishwasher must be fitted with anti-tilt. This comprises two fastening irons which are screwed into place as illus- trated.

The dishwasher is then pushed in so that the fastening irons grip onto the rear feet. The dishwasher cannot now tilt in the event a load is placed on the open door. If the dishwasher is to be fully freestanding, both side panels and the work top should be fitted. These accessories can be purchased where you purchased the dishwasher.

Tip!

A machine with side panels and a counter top (freestanding) can, of course, also be installed as a built-in unit.

C. Semi-freestanding

If the dishwasher is positioned so that either side is visible, a side panel can be fitted. These accessories can be purchased where you purchased the dishwasher.

Freestanding installation

413

455
-
	47
	5	600

CAUTION!

A fully freestanding dishwasher must be fitted with anti-tilt.

28