To prevent kinks, pull the drain hose and the connecting pipe.
Installing the plinth
(Only with kick-plate as accessory)
The dishwasher has two kick-plates (some models).
The taller one should be used if the machine is to be 850 - 870 mm high and the depth of the plinth can be varied between 45 - 105 mm.The lower one is to be used if the machine will be 820 - 845
mmwith a plinth depth of between 50 - 105 mm. Attach the enclosed felt insulation to the kick- plate (some models).
Set the correct plinth depth as follows:
1.Bring the grey hooks towards each other and pull out the brackets as far as required. Press in the catches so that they lock the brackets in place.
2.Suspend the kick-plate from the brackets by pushing into the slots.
Not all models
Fitting fixed kick-plate
Fitting strip seal
(on floor plinth covering plate)
Proceed as follows:
1.Remove the plastic plinth by gripping with both hands under the plastic plinth(A), and break outwards and upwards.
B
A
Screw the dishwasher into place
2.Undo the two screws on the covering plate(B).
3.Glue the accompanying rubber strip(C) to the underside of the covering plate (against the floor).
4.Screw the covering plate back into place. Adjust the covering plate so that the rubber strip is just in contact with the floor.
The enclosed plastic plugs are used for covering the screw holes if the dishwasher is to be screwed at the sides. After fixing check that the front feet are in contact with the floor.
x
x
C
5. Replace the plastic plinth
31
