Troubleshooting
PROBLEM | SOLUTION |
Oven will not | • Check to make sure the cycle is not set for a delayed start. See pages |
| • Check if door is closed. |
| • Check if control is in Sabbath Mode. See page 15. |
| • Oven may be over 400° F. Oven temperature must be below 400° F to program a |
| clean cycle. |
|
|
Oven did not clean properly. | • Longer cleaning time may be needed. |
| • Excessive spillovers, especially sugary and/or acidic foods, were not removed prior |
| to the |
|
|
Oven door will not unlock after | • Oven interior is still hot. Allow about one hour for the oven to cool after the |
completion of a | |
| word is not displayed. |
| • The control and door may be locked. See page 9. |
|
|
Moisture collects on oven window | • This is normal when cooking foods high in moisture. |
or steam comes from oven vent. | • Excessive moisture was used when cleaning the window. |
|
|
There is a strong odor or light | • This is normal for a new range and will disappear after a few uses. Initiating a clean |
smoke when oven is turned on. | cycle will “burn off” the odors more quickly. |
| • Turning on a ventilation fan will help remove the smoke and/or odor. |
| • Excessive food soils on the oven bottom. Use a |
|
|
Fault Codes | • BAKE or LOCK may flash rapidly in the display to alert you if there is an error |
| or a problem. If BAKE or LOCK appear in the display, press the CANCEL pad. |
| If BAKE or LOCK continue to flash, disconnect power to the appliance. Wait a |
| few minutes, and then reconnect power. If the flashing still continues, |
| disconnect power to the appliance and call an authorized servicer. |
| • If the oven is heavily soiled, excessive flareups may result in a fault code during |
| cleaning. Press the CANCEL pad and allow the oven to cool completely, wipe out |
| excess soil, then reset the clean cycle. If the fault code reappears, contact an |
| authorized servicer. |
|
|
Noises may be heard. | • The oven makes several low level noises. You may hear the oven relays as they go on |
| and off. This is normal. |
| • As the oven heats and cools, you may hear sounds of metal parts expanding and |
| contracting. This is normal and will not damage your appliance. |
|
|
There are no beeps and | • Oven may be in Sabbath Mode. See page 15. |
no display. |
|
|
|
25
