NOTE: These instructions are written for element cleaning and element replacement for the lower element. If it is necessary to clean or replace the upper element, then repeat these instructions.
To remove the element from your tank in order to clean or replace it:
1.Before beginning turn “OFF” the electric power supply to the water heater.
FIGURE 31.
2.Turn off the water supply to the water heater at the water
FIGURE 32.
3.Attach a hose to the water heater drain valve and put the other end in a floor drain or outdoors. Open the water heater drain valve. Open a nearby hot water faucet which will relieve pressure in the water heater and speed draining.
FIGURE 33.
FIGURE 34.
5.Remove the insulation cap with handle to expose the terminal cover.
FIGURE 34.
6.Lift out the tab as shown to unclip the terminal cover from the thermostat. The terminal cover can now be removed from the thermostat.
FIGURE 35.
7.Disconnect the two wires on the element and unscrew the old element from the tank.
The water passing out of the drain valve may be extremely hot. To avoid being scalded, make sure all connections are tight and that the water flow is directed away from any person.
4. Remove the two screws securing the access panel, and |
|
remove panel. | FIGURE 36. |
20
