Instructions for Installation (cont’d)
29.Fasten wall plate loosely to the wall in position shown using the three screws provided in the plastic bag. Wall anchors are recommended for drywall installation. Place a level on top of the wall plate, adjust until level, and then tighten screws to secure wall plate.
WALL
PLATE
REMOTE
THERMOSTAT
CABLE
WALL
ANCHORS
MOUNTING
SCREWS
30.Strip the remote thermostat cable outer insulation back 11⁄4 inches. Strip the ends 1⁄4 inch on each of the six colored wires.
ORANGE/WHITE |
|
|
|
| .250″ |
ORANGE | GREEN/WHITE | GREEN | BLUE/WHITE | BLUE | |
|
|
|
|
| 1.250″ |
CAUTION
The six colored insulated wires must be installed in the terminal connector exactly as shown for the thermostat to operate correctly.
32.Carefully plug the wired terminal connector to the mating pins on the thermostat back. Connector will install in one direction only as shown.
BACK OF
THERMOSTAT
ORANGE/WHITE | THERMOSTAT |
CABLE | |
| BLUE |
| BLUE/WHITE |
ORANGE | GREEN |
| |
GREEN/WHITE |
|
TERMINAL |
|
CONNECTOR |
|
33.Place thermostat over wall plate, press firmly, and thermostat will snap into place on the wall plate.
31.Using the terminal connector removed in Step 12, insert the six colored insulated wires in the remote thermostat cable into the numbered slots in the terminal connector and tight- en each screw to secure each wire. Be sure to arrange wires in
34. Turn “ON” electric power to water heater.
exact color sequence as shown.
ORANGE/WHITE | ORANGE | GREEN/WHITE | GREEN BLUE/WHITE BLUE | |
6 | 5 | 4 | 3 | 2 1 |
TERMINAL
CONNECTOR
TERMINAL
CONNECTOR
THERMOSTAT
CABLE
35.Read Temperature Regulation Warning and Temperature Settings, then proceed to Programming the Thermostat.
21
