Instructions for Installation (cont’d)
Selecting Thermostat Location (cont’d)
22.Guide the end of the remote thermostat cable through the hole where the black plug was removed in the left junction box cover.
REMOTE
THERMOSTAT
CABLE
LEFT JUNCTION
BOX COVER
25.Carefully press the terminal connector and connected wires down into the water heater junction box.
26.A
INSULATING
REMOTESTRAIN-RELIEF
THERMOSTATBUSHING CABLE
TERMINAL
CONNECTOR
23.Strip the end of the remote thermostat cable outer insulation back 11⁄4 inches. Strip the ends 1⁄4 inch on each of the six col- ored wires.
ORANGE/WHITE |
|
|
|
| .250″ |
ORANGE | GREEN/WHITE | GREEN | BLUE/WHITE | BLUE | |
|
|
|
|
| 1.250″ |
24.Loosen each screw in the terminal connector one at a time and insert wire with the same color insulation into each numbered slot. Tighten each screw securely making sure both wires in each slot are tight.
| TERMINAL | |
REMOTE | CONNECTOR | |
| ||
THERMOSTAT | THERMOSTAT | |
CABLE | ||
CABLE FROM | ||
| ||
| WATER HEATER |
27.Replace the right junction box cover using the screw provid- ed. This completes the remote thermostat wiring at the water heater.
REMOTE THERMOSTAT INSTALLATION AND WIRING
28.Locate the 6 inches of remote thermostat cable protruding through the wall opening (from Step 8). Using the wall plate removed in Step 11, pull the cable through opening near cen- ter of wall plate.
WALL
PLATE
WALL
OPENING
REMOTE
THERMOSTAT
CABLE
20