EFORE YOU CALL CONT.
|
| Be sure the door is tightly dosed. | |
|
| Plugcord into a live electrical outlet. (Tub light should illuminate). | |
|
| Check fuse or reset circuit breaker. | |
Won't Fill |
| Pressthe start/pause | pad. |
|
| Turn both faucets on fully. | |
|
| Straighten inlet hoses. |
|
|
| Disconnect hoses and clean screens. Hose filter screens may be plugged. | |
|
| Open and close the door, then push the start/pause pad. | |
|
| Check fuse or reset circuit breaker. | |
Won't Tumble |
| Close the door and pressthe start/pause pad. For your safety,the clothes washer will not | |
|
| tumble or spin unlessthe door is closed. | |
Door Locked | Shut; | Press the start/pause | pad to stop the machine. |
Will Not Open | It may take a few moments for the door lock mechanismto disengage. | ||
|
| Open the door and wash the lower portion of the gray door seal with a solution of I cup | |
|
| chlorine bleach to 2 cups water. | |
Freshening |
| Select the following control panelsetting: Cotton/Sturdy, Hot/Cold, Heavy soil setting. | |
Your Washer |
| Fill the bleach dispenser cup with liquid chlorine bleach and start the washer. | |
|
| Pour an additional I/2 cup bleach into the detergent dispenser as the washer isfilling. | |
|
| Allow the washer to complete the cycle. | |
|
| At the end of the cycle,open the door and dry the gray door seal. | |
| • | Clothes washer should be leveled properly as outlined in installation instructions. | |
| • Check the leveling leg lock nuts are tightened. | ||
Is Noisy | • | Be sure rubber feet are installed on leveling legs. | |
| • | Weak floors can causevibration and walking. | |
| • | For information on normal operating sounds,see page 12. | |
For further assistance, call Maytag Customer Service
II
